Right process to update DataSet and associated fields when profiling is updated

Question

Hello,

As sometimes I add additional profiling fields, I need to update my dataset in accordance.

But I have often an erratic behavior when I try to update Dataset and associated fields into my report

* Dataset has sometimes doublons fields
* Dataset has sometimes wrong column binding
* ...

Then I have errors when my reports are generated.
So my question is what is the right process to update my dataset when profiling fields are added into my MEDINI project?

medini_1024169437 · Answer

Ha ha, all good, that's what this community forum is good for and all about (who reads documents?) :-)

Jan

medini_1053080245 · Answer

yes you are right ! That was my conclusion...but next time I will read guideline carefully if it is already mentioned ;-)

Thx

medini_1024169437 · Answer

Romain,

I typically update the data set first and then I bind the DS again to the control and select the new fields I want to add.

I avoid using refresh because it will bind all fields and I don't need them. That's also what the training guide says at page 45

Regards

Jan