[FMEDA] Copy evaluation of previous projectz

Question

Good morning,

needed is a script that copies the Evaluation (FMEDA related) to the new Project.

Used for:

New Project, that differs not that much from a previous Project, e.g. a new sample Phase.

That means, the old and the new BOM are not equal, but maybe a lof of components are.

Necessary:

Script shall

- compare if the old component name also exists in the new project

- components also can have ports

- further perform the steps below for equal failure modes

-- copy the 'safety related' marking

-- copy failure description

-- copy the single Point and multipoint failure marking

-- copy the used safety mechanism

-- copy the diagnostic Coverage value

- the user shall have the possibility to only select a part of the FMEDA (seperate blocks)

I hope everything is described what is necessary. Please ask if it is unclear.

Best Regards

Benedikt

medini_1024169437 · Answer

Here is a rough skeleton that does the initial setup and crawls the two models.

Missing part is the real synchronization. Benedikt, please check the initial setup and extend as you like.

If you have concerns or troubles, repost the code and come back here.

I tried to make each step straight as I could.

Jan

medini_1024169437 · Answer

Hi Benedikt,

that's quite something to do for a script. I can come up with some snippets and post it here, you may continue from there.

Jan