Failure Rate (FIT) Column in HW-FMEA

Question

Lieber Jan,

ich danke dir immer für die hervorragende Unterstützung. :)

One of our customers want to see "Failure Rate (FIT)" in FMEA simply, yet it is shown in property view.

(Note: Because they concentrate to develop HW in P/T, need actually HW-FMEA.)

I think it's so good idea on HW-engineer side and it's not so difficult to develope or script.

Danke i.V.

Seungyong

medini_1034854528 · Answer

Hi Jan,

jut. I'll try to meet the Engineer of the customer soon and discuss about it. :)

Schöne Grüße nach Berlin.

Seungyong

medini_1024169437 · Answer

Hello Seungyong,

Urlaub war fantastisch, danke!

I think its feasible to script any kind of such additional column. However, you should clarify with the customer what the difference is between the FIT value (column) they seek for and the column mentioned by Eckhardt (Total Failure Rate). To further help, I need some idea what this FIT value is all derived from.

See you in Berlin!

Jan

medini_1034854528 · Answer

Lieber Jan,

war dein Urlaub gut?

Between your vacancy another (but similar) has appeared :)

I already put our customer onto useful tip of Herr Holz. But they want to go more complex way.

(It means that this issue is still ongoing.)

They've like to make a new column on FMEA (e.g. TSC FMEA).

Especially "FIT"-Column which should type "HW Fault in HW-Part" and appear HW-Part (also Failure Cuase) Failure Rate in FIT.

Is it possible to realize with script?

Ich hoffe and noch mal betonne, dass wir uns in September (noch paaaaaaar Tage später) in Berlin treffen. ;)